Particle deformation and coating deposition behavior in cold spray additive manufactured aluminum deposit on copper substrate by simulation and experiment

Xiawei Yang, Tingxi Meng, Yu Su, Xiaoxia Chai, Zhenguo Guo, Tiejun Ma, Shuo Yin, Wenya Li

科研成果: 期刊稿件文章同行评审

2 引用 (Scopus)

摘要

In this study, the particle deformation and coating deposition behavior in cold spray additive manufactured (CSAM) aluminum deposit on copper substrate were studied by simulation and experiment. The mechanisms of single particle impact deposition during CSAM were investigated using simulation modeling and the numerical simulation results were validated. The effect of particle collision velocity, preheating temperature and size of particle on CSAM process were studied. The porosity of the coating sprayed by powder particle with large size is smaller than that of the coating with small size, and the quality of bonding surface between coating and substrate obtained by large particle is significantly better than that of the small particle. The microstructure of the substrate after CSAM process with small particle size powder at the gas pressure 2.2 MPa was analyzed. The bonding strength of coating with large particle size powder is greater than that of small particle size powder under the same gas pressure. The particle deformation of the coating side deposited by small particle powder after tensile fracture is significantly lower than that of the coating prepared by the large particle powder.

源语言英语
页(从-至)2879-2890
页数12
期刊Journal of Materials Research and Technology
30
DOI
出版状态已出版 - 1 5月 2024

指纹

探究 'Particle deformation and coating deposition behavior in cold spray additive manufactured aluminum deposit on copper substrate by simulation and experiment' 的科研主题。它们共同构成独一无二的指纹。

引用此