Microstructure and Properties of Mn-Cu-Based Damping Alloys Prepared by Ball Milling and Hot-Press Sintering

A Mn-Cu-based damping alloy with a nominal composition of 70Mn-24Cu-3Zn-3Al (at.%) was prepared by ball milling of pure elemental powders and subsequent hot-press sintering of powder mixture at 750 and 825 °C for 2 h. For comparison, this alloy was also prepared by induction melting technology and then homogenized at 850 °C for 24 h. Further, they were aged at 430 °C for 2 h. The microstructure, damping capacity and microhardness of the hot-press-sintered and induction-melted alloys have been investigated. The results show that the microstructure of the powder mixture upon ball milling mainly comprises convoluted composite particles containing α-Mn and γ-Cu phases, and isolated α-Mn ones around. The high compactness of the alloys is obtained after hot-press sintering (94.8 and 98.6% at 750 and 825 °C, respectively). At a holding temperature of 750 °C, the microstructure of the alloy is primarily composed of γ-MnCu, γ-CuMn and α-Mn grains. With increasing the target temperature to 825 °C, the single γ-MnCu solid solution has been formed in the alloy by diffusion of Mn etc. into γ-Cu lattices. The hot-press-sintered alloys (especially at 825 °C) possess relatively high damping capacity although which is still lower than that of induction-melted one. In contrast, the microhardness of the hot-press-sintered alloys (especially at 750 °C) is obviously higher than that of the induction-melted one.