TY - JOUR
T1 - Investigation of high temperature effect on CFRP cutting mechanism based on a temperature controlled orthogonal cutting experiment
AU - Hou, Guoyi
AU - Luo, Bin
AU - Zhang, Kaifu
AU - Luo, Yingxin
AU - Cheng, Hui
AU - Cao, Sipeng
AU - Li, Yuan
N1 - Publisher Copyright:
© 2021 Elsevier Ltd
PY - 2021/7/15
Y1 - 2021/7/15
N2 - CFRP has been gradually used in the load-carrying structure with thicker component and stricter damage tolerance in aviation industry. However, the heat accumulation always occurs at hole exit-ply during thick CFRP drilling, resulting in temperature even higher than the glass transition temperature (Tg) of matrix, affected by which severe damages will occur based on an unknown cutting mechanism. Therefore, to investigate the new mechanism, this paper proposed a temperature controlled orthogonal cutting experiment by heating the cutting area to specified high temperature ranges (below and above Tg) before cutting. The results show that the resin matrix will be only softened by the high temperature below Tg and lose part of its strength, but the cutting mechanism is almost not changed. As for temperature above Tg, the resin matrix will be heated into molten state thereby losing the support function for machined fibers, which changes the cutting mechanism at 90° <θ < 180° into low efficiency cutting mode controlled by compressing stress. The fibers that lose support will be over bent and broken by flank face, and severe thermal mechanical damages including loose face, matrix cracking and fiber pull out can be captured at θ ~ 150° of hole wall near exit.
AB - CFRP has been gradually used in the load-carrying structure with thicker component and stricter damage tolerance in aviation industry. However, the heat accumulation always occurs at hole exit-ply during thick CFRP drilling, resulting in temperature even higher than the glass transition temperature (Tg) of matrix, affected by which severe damages will occur based on an unknown cutting mechanism. Therefore, to investigate the new mechanism, this paper proposed a temperature controlled orthogonal cutting experiment by heating the cutting area to specified high temperature ranges (below and above Tg) before cutting. The results show that the resin matrix will be only softened by the high temperature below Tg and lose part of its strength, but the cutting mechanism is almost not changed. As for temperature above Tg, the resin matrix will be heated into molten state thereby losing the support function for machined fibers, which changes the cutting mechanism at 90° <θ < 180° into low efficiency cutting mode controlled by compressing stress. The fibers that lose support will be over bent and broken by flank face, and severe thermal mechanical damages including loose face, matrix cracking and fiber pull out can be captured at θ ~ 150° of hole wall near exit.
KW - CFRP drilling
KW - Cutting mechanism
KW - Cutting temperature
KW - Thermal mechanical damages
UR - https://www.scopus.com/pages/publications/85107146654
U2 - 10.1016/j.compstruct.2021.113967
DO - 10.1016/j.compstruct.2021.113967
M3 - 文章
AN - SCOPUS:85107146654
SN - 0263-8223
VL - 268
JO - Composite Structures
JF - Composite Structures
M1 - 113967
ER -