Corrigendum to “The fracture toughness and its prediction model for Ti–5Al–5Mo–5V–1Cr–1Fe titanium alloy with basket-weave microstructure” (J. Alloys Compd. (2015) 632 (748–755) (S0925838815003151) (10.1016/j.jallcom.2015.01.217))

The authors regret 1. Fig. 5 (e) is inappropriately used, please replace it by the following figure. [Formula presented] 2. In Section 2, due to the same original material used for testing, the microstructure preparation and description are similar with two other papers “X.H. Shi, W.D. Zeng, et al., Materials Science & Engineering A 621 (2015) 143–148 ” and “X.H Shi, W.D. Zeng, et al., Journal of Alloys and Compounds 631 (2015) 340–349 ”. In addition, to make readers get a better understanding of the discussion part in these three papers, the basic tensile properties of this alloy were all listed. However, as an amateur at that time, the knowledge of submission requirements is insufficient, thus the author forget referring this part in the latterly published papers. Thus, the tensile properties listed in Table 3 in this paper and Table 4 in “Journal of Alloys and Compounds 631 (2015) 340–349 ” should refer Materials Science & Engineering A 621 (2015) 143–148 (http://dx.doi.org/10.1016/j.msea.2014.10.022)The authors would like to apologise for any inconvenience caused.