Anisotropic Performance of High-Quality MAPbBr₃Single-Crystal Wafers

It has been proved that bulk single crystals of a halide perovskite behave much better than its polycrystalline counterparts in multiple application scenarios. Thus, the growth of large-sized and high-quality single crystals is significant to guarantee their ultimate device performances. Here, based on our recently invented settled temperature and controlled antisolvent diffusion system, improvements achieved in this work include the following: (1) We modified the growth system to optimize the control over both mass and heat transport to alleviate defect formation. State-of-the-art-quality MAPbBr3 crystals were grown, and from the bulk crystals, differently oriented crystalline wafers were fabricated with the full width at half-maximum of X-ray rocking curves of 40-86 arcsec. (2) The optical band gaps revealed no anisotropy on differently oriented wafers, whereas the refractive index and extinction coefficient exhibited obvious anisotropy. (3) Angle-resolved polarized Raman spectra demonstrate distinct in-plane anisotropy on (100) and (110) wafers but not on the (111) wafer. The equilibrium MA+ orientations are deduced to adopt the <111> direction with the antiparallel MA+ orientation between adjacent domains. (4) Radiation detectors fabricated on differently oriented wafers proved photoresponse anisotropy to both visible and X-ray radiation, following a general order of (100) > (110) > (111). Because anisotropy is an inevitable issue for various applications employing crystalline materials, this study, based on the clarification of the debatable intrinsic dipole configuration in the pseudocubic crystal lattice, will provide quantitative information on physicochemical property anisotropy and subsequently facilitate optimization of device performance referring to crystal orientations of halide perovskite crystals.